Ultrasonic Embossing Machine Installation

1. Remove the packaging, check the equipment surface and parts have no damage marks, check whether the screws loose, electrical connectors are locked, accessories are Complete.

2. Equipment should be placed on a flat hard ground, require lace machine to deviate from the heat source at least 0.5 meters, and to ensure that the lace machine at least 1 meters, around at least 0.5 meters of space, in order to Operate.

3. Check the voltage requirements of the signage on the back of the vibrating box and make sure that the system is grounded properly.

4. Connect the device to the power supply and air source, and be careful to turn off the power switch First. Note the voltage requirements for this machine: ac220v,50-60hz

5. The air line is connected to a clean and lubricant-free compressed air source with a nominal operating pressure of 0.6MPa.

Instructions for use Before using the new machine, you must read the manual of the ultrasonic press, and be familiar with the contents of this Manual.

Related Products

Raising Machine for Velvet

Raising Machien for T-shirt

Combined Polish-shearing Machine for Blankets

Sueding Machine with Sanding Roller

Oil Hearing Stenter Machine for Cotton

Stenter Machien for Wool Fabric